Step 02.44 — Close the chapter¶
Step 44 of 44 with a helper · Chapter 02 — Z drives, Z idlers, Z rails, deck panel
Tap to enlarge
Parts: none.
Do: Use it as the marker that the Z chapter is done. The printer has been upright since Step 02.38. Work through Checkpoint 02 and make sure the measured deck thickness is in your build log.
Check
Checkpoint 02 fully ticked.
Helper Ticks the checkpoint list while you point at each item on the machine.
What you're looking at
Manual p.51 is a divider page with no assembly content: the marker that the Z chapter is finished. Look the work over now, because the gantry and the electronics bay are about to cover most of what you just built.
Good stopping point · ~25 min since the last one
all four Z idlers mounted, each aligned with the drive below it, all eight M5×30 tight, printer back upright on its feet. Work through Checkpoint 02 before the gantry starts hiding this.
Source: Voron manual p.51