Batch B00 — Calibration & jigs

Time: 4.0 h · Sessions: ~15 min one-time slicer and filament setup, then Step B00.8's plate review · Steps: 9

Start the chapter · Resume · Read the whole chapter on one page

StartBefore you start

Step B00.0One-time PrusaSlicer setup

NoteBefore B00: belt and hot-bed checks

Step B00.8Review every plate in PrusaSlicer, togetherwith a helper

Step B00.1Filament prep

Step B00.2Load plate B00-P1

Step B00.3Pre-print checks

Step B00.4Print

Step B00.5Inspect: Gate A (the cube, no kit needed)with a helper

Step B00.6Sort into bins

Step B00.7Gate B, bore and inserts now, rail on kit day

Checkpoint B00Tick before moving on

Gather per session — what to lay out before each bench segment.

• Step B00.0 · ~10 min — nothing to lay out
• Step B00.8 · ~20 min — nothing to lay out
• Step B00.1 · ~10 min — nothing to lay out
• Steps B00.2–B00.5 · ~15 min — 6 files, 8 objects — 4.0 h, 52 g (PrusaSlicer 2.9.6 estimate) · Voron_Design_Cube_v7 — from bin 00-jigs · Heatset_Practice — from bin 00-jigs · MGN12_rail_guide_x2 ×2 — from bin 00-jigs · MGN9_rail_guide_x2 ×2 — from bin 00-jigs · pulley_jig — from bin 00-jigs · z_drive_retainer_a_x2 ×1 — from bin 02-Z0, 02-Z2
• Step B00.6 · ~10 min — nothing to lay out
• Step B00.7 · ~15 min — nothing to lay out

← Ch 14 · Manual index · Batch B01 →