Step 07.14 — A belt: run forward down the right Y extrusion¶
Step 14 of 39 · Chapter 07 — A/B belts and tensioning
Tap to enlarge
Parts:
- the A belt · already on the bench
Do: Run the belt forward along the right Y extrusion, past the right XY joint without wrapping it, all the way to the front-right idler. The left-hand image on p.134 shows the belt passing the joint at its own height.
Check
The belt clears the XY joint's printed parts entirely, no rub, no contact, and is at the same height at both ends of the run.
What you're looking at
The outbound A run passes the right XY joint at its own height without wrapping it; that joint comes on the return run. Sighting the belt at the same height at both ends of a long run catches a half-twist.
Source: Voron manual p.134