Step 07.19 — B belt: run rearward up the left outer run, past the left XY joint¶
Step 19 of 39 · Chapter 07 — A/B belts and tensioning
Tap to enlarge
Parts:
- the B belt · already on the bench
Do: Run the belt rearward along the left Y extrusion on the outer run, past the left XY joint without wrapping anything, all the way to the rear-left B drive unit.
Check
The belt clears the joint's printed parts and the inner run, both left-side runs stay parallel, and the height is the same at both ends.
What you're looking at
B's return run up the left side, outboard of the forward run. It passes the left XY joint at its own height without touching it, on to the B drive at the rear-left. Sight both ends at the same height to catch a half-twist.
Source: Voron manual p.137