Step B00.0 — One-time PrusaSlicer setup¶
Step 1 of 9 · Batch B00 — Calibration & jigs
(no image — see text)
Do:
- PrusaSlicer 2.9.6, Configuration → Configuration Wizard: Prusa FFF, Prusa CORE One & CORE One+.
- Tick the 0.4 HF nozzle even with plain 0.4 ticked; filament Prusament ASA; Finish.
- File → Open Project:
slicer/plates/B00-P1.3mf; accept any profile dialog.
Check
All three preset boxes read (modified): Prusa CORE One HF0.4 nozzle (modified), 0.20mm STRUCTURAL @COREONE 0.4 (modified), Prusament ASA @COREONE HF0.4 - Voron black.
Caution
The printer box's (modified) is the cold-probe start G-code, baked into all 22 projects. Leave it: never reset that box to its system value, and never pick the - coldstart preset first, because the project already carries the identical block.
Caution
The project did not load if any box lacks (modified), the filament box reads bare Prusament ASA @COREONE HF0.4, the estimate at Step B00.2 is wrong, or the printer box names another printer.
Good stopping point · ~10 min since the last one
wizard run with the 0.4 HF nozzle, B00-P1 open and showing "(modified)" / " - Voron black". Nothing printing.
Source: 00-slicer-setup § One-time PrusaSlicer setup · 00-slicer-setup § Committed projects · PrusaSlicer releases