Batch B00 › Plate review, B00-P1 and the gates6 / 9

Step B00.4 — Print

Step 6 of 9 · Batch B00 — Calibration & jigs

(no image — see text)

Do:

1. Slice, then Export G-code to USB or Send to printer.
2. Start it, watch the first layer for 2–3 minutes.
3. Gappy beads: long-press the knob, nudge Live Adjust Z, then find the cause before the next plate.

Check

First layer smooth, no gaps between beads, no ridging, and either no Live Adjust Z nudge or its cause written in the log.

Tip

expect 15–25 minutes of chamber heating before the purge (verify on bench), not in the 4.0 h. Paused or stopped: When the printer stops.

Source: 00-slicer-setup § Calibration sequence, item 3 · Prusa KB — Live Adjust Z · Ellis — first layer squish · print plan §4.1 — how these numbers were produced

← PreviousStep B00.3 — Pre-print checks

Next →Step B00.5 — Inspect: Gate A (the cube, no kit needed)