Batch B017 / 8

Step B01.7 — Inspect

Step 7 of 8 with a helper · Batch B01 — Z drive assemblies

(no image — see text)

Do:

1. Now: caliper each z_drive_main and z_drive_retainer 625-2RS pocket, a 16.30 mm bore.
2. Log every reading.
3. Kit day: thumb a real 625-2RS into every seat, no rocking.

Check

Every pocket reads 16.30 mm ±0.15. A part outside that is reprinted, never forced.

Helper Reads each caliper number back aloud and writes it into the log.

Good stopping point · ~15 min since the last one

every pocket calipered and logged. Nothing pressed or inserted: the bearings are a kit-day row, and Ch 02 Step 02.04 seats the inserts with the parts sorted.

Source: print plan §5.2 — checkpoint after each batch · 00-slicer-setup § Gate B · Voron materials — shrinkage 100 %

← PreviousStep B01.6 — Print plate B01-P2

Next →Step B01.8 — Sort into bins