Step B05.5 — Sort into bins¶
Step 5 of 5 with a helper · Batch B05 — Z joints + Z chain
(no image — see text)
Do: Sort off the plate diagram: number to legend, colour to bin, bin id on the part. Mark plate id and date on a hidden face. Labels: bin-labels sheet. The chain anchor and guide go to 10-chains, not 06-Z-joints.
Check
one rail stop in each 02-Z corner bin; 4 joint pairs in 06-Z-joints with B02's four lower belt clips; anchor and guide in 10-chains.
Helper Matches each part's number to the diagram legend and drops it in its bin.
B05-P1
| bin | parts off this plate |
|---|---|
02-Z0 — Z0 corner (front-left, _a hand) |
z_rail_stop |
02-Z1 — Z1 corner (rear-left, _b hand) |
z_rail_stop |
02-Z2 — Z2 corner (rear-right, _a hand) |
z_rail_stop |
02-Z3 — Z3 corner (front-right, _b hand) |
z_rail_stop |
| 06-Z-joints — Z joints and lower Z belt clips | z_joint_lower ×4, z_joint_upper ×4 |
| 10-chains — Z cable chain anchor, guide, retainer | z_chain_bottom_anchor, z_chain_guide |
Good stopping point · ~10 min since the last one
joints in 06-Z-joints, anchor and guide in 10-chains, bin ids written. Nothing is pressed and the rail stops stay bagged.
Source: print plan §9 — batch summary · print plan §2 — which parts gate which step · print/README § Bins