Step B09.10 — Load plate B09-P5¶
Step 10 of 13 with a helper · Batch B09 — Panels, filtration, spool
Gather for this segment — steps B09.10–B09.11 (~5 min)
Hardware
- 2 files, 16 pieces — 4.3 h, 56 g (PrusaSlicer 2.9.6 estimate)
- no brim in the project
Printed parts
corner_panel_clip_6mm×8 — from bin 11-clips-6mmmidspan_panel_clip_6mm×8 — from bin 11-clips-6mm
Parts:
-
corner_panel_clip_6mm×8 -
midspan_panel_clip_6mm×8 - 2 files, 16 pieces — 4.3 h, 56 g (PrusaSlicer 2.9.6 estimate)
- no brim in the project
Do: Open slicer/plates/B09-P5.3mf with File → Open Project. The arrangement, brims and overrides
are already in it. Confirm it loaded as described rather than rebuilding it.
Check
Counts match: 8 corner, 8 midspan; no brim outline anywhere.
Helper Names the bin colour of each part on the sorting diagram while you open the project.
What you're looking at
Sorting diagram, drawn from the committed project: every part numbered and filled in the colour of its bin, bin id on the part; the legend reads # · STL · bin (chapter · steps). Sort at Step B09.13.
Source: print plan §3 — the batches · 00-slicer-setup § Committed projects · 00-slicer-setup § Orientation & brim · print plan §6 — conditional / verify items