Step 00.28 — Blind joints (p.10)¶
Step 28 of 32 pre-kit · Chapter 00 — Before you start
Tap to enlarge
Parts: none.
Do:
- Watch the blind-joint video once before Ch 01.
- The screw goes in before the two extrusions are brought together; you tighten it through the access hole afterwards.
Check
You can point at the access hole on a 2020 extrusion and describe which way the BHCS goes in.
What you're looking at
Manual p.10, the blind joint, the joint the frame is built from. A button-head screw threads into the tapped bore in the end of one extrusion, its head captured inside the slot of the mating extrusion, tightened through a small access hole in the side.
Source: Voron manual p.10 · blind-joint video · Video: Part 1 @0:54:58