Skip to content
Ch 0114 / 22

Step 01.14 — Check the four vertical faces

Step 14 of 22 with a helper · Chapter 01 — Frame

Full page

Tap to enlarge

Parts: none.

Do:

  1. Measure both diagonals on each of the four vertical faces and square their inside corners, top and bottom.
  2. A face that will not come square means a joint not fully home: back it off, reseat it, re-tighten.

check Check

Each face's two diagonals equal and every corner reads 90°. A 350 pair lands near 735 mm, from 510 × 530 outside.

helperHelper Holds the square flat against each upright and calls out any gap.

What you're looking at

Manual p.21 shows the four upright faces of the cube, each measured across its own diagonals. This is the check the first two cannot make: it catches a frame leaning over like a square-based prism rather than a rectangular box.

Source: Voron manual p.21 · Video: Part 1 @1:13:15

← PreviousStep 01.13 — Square the top square and lock it

Next →Step 01.15 — Check the frame sits without rock