Ch 0120 / 22
Step 01.20 — Final squareness verification¶
Step 20 of 22 with a helper · Chapter 01 — Frame
Tap to enlarge
Parts: none.
Do: With everything torqued, walk the whole check once more: both bottom diagonals, both top diagonals, both diagonals on each of the four vertical faces, machinist square in every inside corner, frame flat on the stone.
Check
Every diagonal pair equal, every corner 90°, no rock. Anything you cannot null out here is permanent. src
Helper Reads each diagonal pair aloud and ticks it off as you go.
What you're looking at
Manual p.21 one last time, on the fully torqued frame with the bed extrusions in. Bolting the bed extrusions in can pull a square frame out of square, so this is the pass whose numbers go in the log.
Source: Voron manual p.21 · frame squaring video · Video: Part 5 @3:15:10