Ch 016 / 22
Step 01.6 — Lay out the bottom square on the reference surface¶
Step 6 of 22 · Chapter 01 — Frame
Tap to enlarge
Gather for this segment — steps 01.6–01.15 (~65 min)
Frame Kit 2.4-350 box
- B extrusion ×4
Tools and consumables
- 3 mm hex key, straight
Already on the bench
- A extrusion ×4, prepared
- M5×16 BHCS ×2, already in the two A extrusions
Parts:
- A extrusion ×4, prepared · already on the bench
Do:
- Lay four A extrusions flat on the stone in a square, taped channel up, each end face pointing into a corner void. They do not touch each other.
- Keep every part flat on the stone.
Check
All four extrusions lie dead flat with no gap under any of them. The four corner voids are square and roughly 20 × 20 mm.
What you're looking at
Manual p.15 shows the first corner: two A extrusions meeting at one B vertical, flat on the build surface. Here all four bottom A extrusions go down first, with a void at each corner where a vertical drops in.
Source: Voron manual p.15 · Video: Part 1 @0:53:47