Skip to content
Ch 017 / 22

Step 01.7 — Join the first vertical to the first corner

Step 7 of 22 with a helper · Chapter 01 — Frame

Full page

Tap to enlarge

Parts:

  • B extrusion ×1 · Frame Kit 2.4-350 box
  • M5×16 BHCS ×2, already in the two A extrusions · already on the bench
  • 3 mm hex key, straight · tool

Do:

  1. Stand a B extrusion in the first corner, access holes facing outward.
  2. Slide it over the two bolt heads and push both A extrusions home.
  3. Snug through each access hole with the 3 mm key. Not tight.

check Check

Both A end faces sit flush against the vertical, its bottom is flush with theirs, and the corner sits flat on the stone.

helperHelper Holds the two A extrusions together at the corner while you snug the bolts.

What you're looking at

Manual p.15 shows the first corner going together: one B extrusion standing in the void with its two access holes on the outward faces. The two horizontals occupy the vertical's inner faces, so only the outer pair can take a driver.

Source: Voron manual p.15

← PreviousStep 01.6 — Lay out the bottom square on the reference surface

Next →Step 01.8 — Add the remaining three verticals and close the bottom square