Ch 019 / 22

Step 01.9 — Snug and check the bottom square

Step 9 of 22 with a helper · Chapter 01 — Frame

Full page

Tap to enlarge

Parts: none.

Do:

1. Press each corner down onto the stone.
2. Snug all 8 bottom bolts in a diagonal pattern: corner 1, corner 3, corner 2, corner 4.
3. Put the machinist square in each of the four inside corners.

Check

All four inside corners read 90° against the square with no light. All four extrusions still touch the stone along their whole length.

Helper Holds the square in each inside corner and calls out any light under the blade.

What you're looking at

Manual p.16 shows the closed bottom square with the machinist square standing in each inside corner. A machinist square is a precision-ground right angle; you are looking for light between its blade and the extrusion.

Source: Voron manual p.16

← PreviousStep 01.8 — Add the remaining three verticals and close the bottom square

Next →Step 01.10 — Fit the four top A extrusions