Step 02.37 — Check the drive did not shift when the tensioner closed¶
Step 37 of 44 · Chapter 02 — Z drives, Z idlers, Z rails, deck panel
Tap to enlarge
Parts: none.
Do: Sight down the section view on the page and compare. The drive body must still sit hard against the corner and square to both extrusions.
Check
No skew, no gap at the corner, belt still fully on both pulleys. If the drive moved, undo the bolts, realign, and redo Steps 02.34–02.35.
What you're looking at
Manual p.46: a section through the finished corner. Closing the cam pushes the motor away from the drive body, and the reaction shoves the body. If it was not seated square when its M5×40 went tight it moves, and the section is how you tell.
Good stopping point · ~30 min since the last one
the Z0 corner is complete: drive body on its two M5×40, motor slid in, cam closed, both M5×10 tight, rubber foot on, and the p.46 section check passed. One corner is a self-contained unit and this is the natural stop.
Source: Voron manual p.46