Ch 0547 / 48
Step 05.47 — Stop here: no belts, no squaring¶
Step 47 of 48 · Chapter 05 — Gantry: X and Y axes, XY joints, X carriage, titanium backers
Tap to enlarge
Parts: none.
Do: Do not cut, route or tension the A/B belts, do not tighten the XY joints "properly", and do not square the gantry. Ch 06 squares it in the frame, with A/B tension released and the lower Z joints dropped.
Check
A/B belts still in their bag. XY joint bolts still only lightly tightened.
What you're looking at
The gantry is complete as a mechanism and deliberately unfinished as a machine. Belts and squaring are held back because the official squaring procedure begins by releasing A/B belt tension; tension it now and Ch 06 simply undoes it.
Source: Voron manual p.107 · Voron docs § V2 Gantry Squaring