Step 06.6 — Fit the lower belt clip¶
Step 6 of 42 · Chapter 06 — Z axis (and Chapter 06b — Gantry squaring)
Tap to enlarge
Parts:
-
[a]_z_belt_clip_lower_x4×1 · bin 06-Z-joints
Do: Drop the lower belt clip onto the belt, indented face down onto the belt. Line up the clip's small hole with the frame's M3 hole and its large hole with the M5 hole.
Check
The clip lies flat with the belt captured under its indented face; both holes line up with the frame underneath, no offset.
What you're looking at
The lower blue clip, one large hole and one small, goes on now, indented face down onto this first belt end. Its look-alike, the twin-hole upper clip, is already on top of each corner from Ch 05.
Source: Voron manual p.111 · Video: Part 4 @0:12:33