Step 07.24 — Fit the right X carriage half to capture the belt ends¶
Step 24 of 39 · Chapter 07 — A/B belts and tensioning
Tap to enlarge
Parts:
- the right X carriage half · already on the bench
- both belts, tails loose · already on the bench
Do: Feed the two loose belt tails into their clamp slots in the right X carriage part, each into the slot at its own height, and offer the part up to the carriage. Don't fasten anything yet.
Check
Both tails are seated in their slots and both belts leave the carriage without twist.
What you're looking at
The right carriage half is the other jaw of the clamp. Each loose tail goes into the slot at its own height, so the two belts stay in their own planes right up to the point where they are gripped.
Source: Voron manual p.139