Step 07.37 — Route the probe cable¶
Step 37 of 39 with a helper · Chapter 07 — A/B belts and tensioning
Tap to enlarge
Parts: none.
Do: Guide the probe cable into the moulded slot in the carriage. Leave the coiled end loose above the carriage until Step 08.50 plugs it into PROBE.
Check
The cable is captive in the slot and clear of both belts and the rail carriage over full travel. Move the carriage end to end.
Helper Slides the X carriage slowly end to end while you watch the probe cable.
What you're looking at
The moulded slot is the one place the probe cable can sit without being caught between the belts and the rail carriage across the full X travel. It plugs into the toolhead board in Ch 08.
Source: Voron manual p.144