Step 07.38 — Hall-effect endstop magnet: skip¶
Step 38 of 39 · Chapter 07 — A/B belts and tensioning
Tap to enlarge
Parts: none.
Do: Nothing.
Check
No magnet in the carriage pocket.
What you're looking at
A page you skip entirely. The pocket shown in the carriage takes a magnet for the hall-effect endstop option; this kit uses a microswitch PCB in the printed endstop pod fitted in Ch 05, so the pocket stays empty.
Caution
Rev D+ / LDO: "PAGE 145 SKIP — The kit does not use hall effect endstops." This kit ships the XY microswitch PCB and the [a]_endstop_pod_D2F_switch printed part (fitted in Ch 05). Do not insert a 3×6 magnet. src (p.145), survey §4.2
Source: Voron manual p.145 · LDO Build Notes § Voron 2.4 build FAQ