Step 07.39 — Fit the A/B drive cable cover¶
Step 39 of 39 · Chapter 07 — A/B belts and tensioning
Parts:
-
[a]_cable_cover×1 · bin 07-X
Do: Clip the accent cable cover onto the drive-unit cable exit. If the A/B motor leads are not yet dressed, leave it off and fit it during the gantry cable routing in Ch 10 instead.
Check
The cover does not touch either belt at any point of travel. Re-run the Step 07.29 rub inspection at that drive unit.
What you're looking at
The [a]_cable_cover is the blue shroud that clips over a drive unit's cable exit and tidies the A/B motor leads. The two belts run past it, so it must never touch them. It goes on now while the rear of the gantry is still open.
Source: STLs/Gantry/AB_Drive_Units/ · Voron manual p.142 · CAD: Voron 2.4r2 STEP @ de7e89d