Skip to content
Ch 08 › B — Clockwork 2 extruder10 / 65

Step 08.10 — Close the guidler arm

Step 10 of 65 · Chapter 08 — Toolhead: Stealthburner, Clockwork 2, Revo HF, Nitehawk-SB V2

Full page

Tap to enlarge

Parts:

  • [a]_guidler_a ×1 · bin 08-CW2
  • [a]_guidler_b ×1 · bin 08-CW2
  • M3×16 SHCS ×1 · Fasteners, Tools & Misc box
  • the greased idler assembly · already on the bench

Do: Join the two guidler halves with one M3×16 SHCS, p.16. Slide the greased idler assembly from 08.9 into the arm from the side, in the orientation p.17 circles: toothed face toward the filament path. Snug only.

check Check

The idler spins freely in the closed arm. The two halves meet with no gap.

What you're looking at

The guidler is the swinging arm that carries the idler: two blue halves joined by a single M3×16 on p.16, with the idler assembly sliding into the joined arm on its own shaft on p.17.

Source: SB manual p.16

← PreviousStep 08.9 — Build the BMG idler assembly and grease it

Next →Step 08.11 — Fit the latch shuttle and the BMG thumbscrew assembly