Step 08.23 — Fit the second motor bolt through the front access hole¶
Step 23 of 65 · Chapter 08 — Toolhead: Stealthburner, Clockwork 2, Revo HF, Nitehawk-SB V2
Tap to enlarge
Parts:
- M3×8 SHCS ×1 · Fasteners, Tools & Misc box
- M3 washer ×1 · Fasteners, Tools & Misc box
Do: Put the washer on the M3×8 SHCS and drive it into the second motor position. It is reached from the front of the extruder through the access hole. Leave this one loose too.
Check
Both motor bolts started, both still finger-loose, and the motor can be nudged in its slots.
What you're looking at
The second motor bolt is reached from the front of the extruder through an access hole. This is the bolt that gets forgotten, and a motor held by one bolt slowly rotates in its slots under load until the mesh is gone.
Source: SB manual p.29