Step 08.25 — Fit the LDO tilted chain anchor¶
Step 25 of 65 · Chapter 08 — Toolhead: Stealthburner, Clockwork 2, Revo HF, Nitehawk-SB V2
Tap to enlarge
Parts:
- CW2 Chain Anchor Tilted ×1 · Electronics 2 box
- M3×20 SHCS ×1 · Fasteners, Tools & Misc box
Do: Sit the anchor onto the rear of the CW2 so its chain face points back along the X extrusion, and fix it with one M3×20 SHCS.
Check
The anchor is solid on the body and its two chain holes face rearwards and slightly up.
What you're looking at
The chain anchor is the terminus of the toolhead's cable run: the umbilical is tied to it, so every pull from the moving drag chain lands on this printed block rather than on the toolboard's connectors.
Source: SB manual p.31