Step 08.4 — Inserts: Clockwork 2 motor plate¶
Step 4 of 65 · Chapter 08 — Toolhead: Stealthburner, Clockwork 2, Revo HF, Nitehawk-SB V2
Parts:
-
motor_plate.stl×1 · bin 08-CW2 - heat-set insert, M3×5×4 ×7 · Fasteners, Tools & Misc box
Do: SB p.12 draws six: three in the motor face, two in the inner face, one in the edge. Top and bottom motor-face inserts sit below the surface; mind the bottom cutout. SB p.13 adds the seventh, for the toolhead PCB.
Check
Lay a steel rule across each insert: no insert stands proud. Count: 7 (verify on bench).
What you're looking at
The motor plate is the other half: the thin 8.2 mm plate with the large central bore that closes the extruder and carries the pancake stepper. Its inserts have to finish below the surface, because one standing proud stops the motor sitting flat.
Source: SB manual p.12 · SB manual p.13