Step 08.41 — Route the hotend fan wires¶
Step 41 of 65 · Chapter 08 — Toolhead: Stealthburner, Clockwork 2, Revo HF, Nitehawk-SB V2
Tap to enlarge
Parts:
- the hotend fan's leads · already on the bench
Do: Lay the fan wires into their channel so they exit on the right side, alongside the LED harness.
Check
All wire exits are on one side; nothing is pinched under the fan frame.
What you're looking at
The fan wires join the LED harness in the same right-hand channel: one bundle, one exit, and nothing trapped under the fan frame.
Source: SB manual p.54