Step 09.1 — Read the end state¶
Step 1 of 36 · Chapter 09 — Electronics bay
Tap to enlarge
Gather for this segment — steps 09.1–09.5 (~30 min)
Electronics 2 box
- DIN rail plastic end cap ×4
Fasteners, Tools & Misc box
- M3 T-nut ×2
- M5×10 BHCS ×4
Other box
- DIN rail ×2
Already on the bench
- the deck panel
- the four deck T-nuts
Parts: none.
Do: Look at the render: the two rails and their geometry are right for your kit, even though three of the four components pictured are wrong. Nothing is fastened to the acrylic except the wire ducts.
Check
The parts on your bench are LDO's Leviathan, LRS-200-24 and Omron SSR, not the manual's Octopus, 5 V PSU and Pi bracket.
What you're looking at
The bay is the space under the deck panel where every electronic part lives. Two DIN rails, the 35 mm steel top-hat rail industrial gear clips onto, run across it: boards on the front rail, power on the rear.
Source: Voron manual p.148 · LDO wiring guide § General Placement · Video: Part 7 @0:05:02