Step 09.8 — Do not build the Pi bracket¶
Step 8 of 36 · Chapter 09 — Electronics bay
Tap to enlarge
Gather for this segment — steps 09.8–09.13 (~30 min)
Electronics 1 box
- AC inlet with integrated switch & fuse ×1
- WAGO 221-415 (5-way) ×3
Fasteners, Tools & Misc box
- M3×5×4 heat-set insert ×3
- M3×8 SHCS ×2
- M5×10 BHCS ×2
- M5 T-nut ×2
Printed parts
power_inlet_IECGS_1mm×1 · bin 09-baywago_221-415_mount_3by5×1 · bin 09-bay
Already on the bench
- the two pre-loaded rear M3 T-nuts
Parts: none.
Do: Skip both pages. Put the Pi aside for step 09.22.
Check
No raspberrypi_bracket or beefy_raspberry_bracket in your printed-parts bin: the print plan never printed them.
What you're looking at
A deliberate skip. The manual mounts the Raspberry Pi on its own printed bracket because its reference machine uses a separate controller board; the Leviathan has a dedicated Pi area with its own standoffs, so both pages are dead here.
Caution
Rev D+ / LDO: SKIP manual p.150–151. LDO's note on p.150 points at the Beefy Raspberry Pi Mount and then says "it does not apply for rev D kits" — the Leviathan has a dedicated Pi mounting area with its own standoffs. src
Source: Voron manual p.150 · Voron manual p.151 · LDO wiring guide § General Placement · LDO Build Notes § Voron 2.4 build FAQ