Step 11.25 — Fit the remaining three Z belt covers¶
Step 26 of 67 with a helper · Chapter 11 — Skirts, panels, Clicky-Clack door, filtration
Tap to enlarge
Parts:
- the three remaining loaded covers · already on the bench
Do: Repeat 11.24 at the other three Z belt corners. Then run the gantry up and down its full travel by hand and watch each cover.
Check
Four covers on, all four belts running clear, no rubbing anywhere in the full Z travel.
Helper Watches each cover and calls out any rub while you move the gantry.
What you're looking at
The remaining three corners are identical. The full-travel run afterwards is the real test: a cover that touches a belt makes noise now and cuts the belt edge over months.
Tip
p.237 is a page of Voron history, nothing to build.
Good stopping point · ~15 min since the last one
all four Z belt covers on, each with its hammerhead nut, and the gantry runs its full Z travel without touching one.
Source: Voron manual p.236 · Voron manual p.237