Step 11.26 — Break out the Nevermore printed supports¶
Step 27 of 67 · Chapter 11 — Skirts, panels, Clicky-Clack door, filtration
(no image — see LDO Nevermore V5 Duo guide)
Gather for this segment — steps 11.26–11.29 (~15 min)
Fasteners, Tools & Misc box
- M3×5×4 heat-set insert ×6
Printed parts
V2_Duo_Plenum×1 · bin 11-nevermoreV2_Duo_Plenum_LID×1 · bin 11-nevermoreRegular_Cartridge×1 · bin 11-nevermoreRegular_Cartridge_Lid×1 · bin 11-nevermore
Tools and consumables
- wire snips
- side cutters
Set out for later steps
- Nevermore 5015 fan ×2
Already on the bench
- the plenum and the cartridge
Parts:
-
V2_Duo_Plenum×1 · bin 11-nevermore -
V2_Duo_Plenum_LID×1 · bin 11-nevermore -
Regular_Cartridge×1 · bin 11-nevermore -
Regular_Cartridge_Lid×1 · bin 11-nevermore
Do: The cartridge and the plenum each carry a built-in printed support. Push them out; they break at the interface. Do not cut them out with a knife.
Check
Both supports removed cleanly, no torn layers on the sealing faces, the cartridge lid slides freely in the cartridge grooves.
What you're looking at
The Nevermore is a recirculating activated-carbon filter that sits inside the chamber and scrubs the fumes ASA gives off. Four printed parts make it: a plenum holding two blower fans, its lid, and a magnetic cartridge with its own lid for the carbon.
Caution
Rev D+ / LDO: you are building the Regular cartridge, not the XL — the XL wants a larger carbon charge and a faster, louder fan. src
Source: LDO Nevermore V5 Duo guide § Preparation · Nevermore Micro repo