Step 11.58 — Fit the second side panel¶
Step 59 of 67 with a helper · Chapter 11 — Skirts, panels, Clicky-Clack door, filtration
Tap to enlarge
Parts:
- side panel, PC, clear, 483×503×3 mm ×1 · Panel Kit box (carton 2)
-
corner_panel_clip_6mm×4 · bin 11-clips-6mm -
midspan_panel_clip_6mm×4 · bin 11-clips-6mm - M3×12 SHCS ×12 · Fasteners, Tools & Misc box
- M3 hammerhead T-nut ×12 · Fasteners, Tools & Misc box
Do: Repeat 11.57 on the left-hand side, the hinge side. All eight clips are fully tight here; nothing on this panel gets replaced.
Check
Both panels on, the gantry clearing both through full travel, all 6 mm clips fitted: 8 corner, 8 midspan. One comes off at 11.63.
Helper Holds the side panel against the clips while you tighten them.
What you're looking at
The same eight clips and twelve screws on the opposite side. When it is done both stocks of 6 mm clips are exactly used up, which is the arithmetic check that the assignment was right.
Good stopping point · ~25 min since the last one
both side panels foam-taped, clipped and screwed, all twenty-four M3×12 in. Both sides are fully on.
Source: Voron manual p.242