Step 13.49 — Inspect the prints, then fit the magnets and the wiper¶
Step 49 of 54 with a helper · Chapter 13 — Initial startup
(no image — see text)
Gather for this segment — steps 13.49–13.50 (~25 min)
Fasteners, Tools & Misc box
- 6×3 mm neodymium magnet ×4
- M3 roll-in T-nut ×4
- M3×8 SHCS ×6
Bin 13-scrubber
- brush bracket, mirrored ×1
- purge bucket, mirrored ×1
- stop bracket ×1
Bin 13-scrubber, bought at Ch 00
- Bambu A1 heatbed nozzle wiper ×1
Tools and consumables
- super glue
- digital caliper
- 2.5 mm hex key
Already on the bench
- the brush bracket with its bucket
Parts:
- 6×3 mm neodymium magnet ×4 · Fasteners, Tools & Misc box
- brush bracket, mirrored ×1 · bin 13-scrubber
- purge bucket, mirrored ×1 · bin 13-scrubber
- Bambu A1 heatbed nozzle wiper ×1 · bin 13-scrubber, bought at Ch 00
- super glue · consumable
- digital caliper · tool
Do:
- Press two magnets into the bracket's underside, then the bucket's two, each attracting the one above it.
- Press the wiper into its seat, bristles up.
- Caliper bracket base to bristle tips, then the bucket's height.
Check
Both readings within 0.2 mm of the printout's inspect line. The bucket hangs square and the magnets sit flush.
Helper Tests each magnet pair and hands them over the right way up.
What you're looking at
Two caliper readings prove the parts match the decision before anything goes on the machine. The bucket hangs under the bracket on four magnets, so it lifts off for emptying.
Caution
A reading more than 0.2 mm off means the wrong file or a bad print. Reprint before anything goes on the machine.
Tip
The pockets are drawn for ASA shrinkage, so the magnets press in. Any that falls out gets a drop of super glue.
Source: Printables 796563 — BOM · slicer/addons/scrubber-796563/remix.py