Step 13.48 — Print the chosen parts on the Core One+¶
Step 48 of 54 with a helper · Chapter 13 — Initial startup
(no image — see text)
Gather for this segment — step 13.48 (~15 min)
Tools and consumables
- Galaxy Black ASA, about 40 g
- the Core One+ with the smooth sheet
Parts:
- Galaxy Black ASA, about 40 g · consumable
- the Core One+ with the smooth sheet · tool
Do:
- In PrusaSlicer 2.9.6, load the files from
measured/withvoron-coreone-asa.ini, as oriented, no supports. - Leave the stop bracket out if the calculator said so.
- Print on the smooth sheet. Once cool, bag the parts in bin
13-scrubber.
Check
The bed holds exactly the files the printout named, and the slice comes to about 2.5 h and 40 g.
Helper Checks each file name on the bed against the printout and ticks it.
What you're looking at
The parts print as one job on the Core One+, outside the plate run. The bracket and bucket file names carry the L and T the generator chose, so what lands on the bed matches your machine.
ASA
set Chamber Filtration to Adv. Filtration before starting, as for every ASA plate.
Good stopping point · ~15 min since the last one
the add-on print is running on the Core One+, about 2.5 h. Leave the parts on the sheet until it has cooled.
Source: print/README.md § Add-on prints · Printables 796563 — print settings