Step B00.1 — Filament prep¶
Step 3 of 9 · Batch B00 — Calibration & jigs
(no image — see text)
Do:
- Mount a fresh or recently-dried spool of Prusament ASA Galaxy Black, ≤2 weeks open.
- On the printer, Load Filament → ASA; it asks for a material type only, and the HF profile lives in the slicer.
Check
Purge is clean black, no PLA/PETG streaking from a prior print.
Good stopping point · ~10 min since the last one
ASA loaded and purged clean, B00-P1 still open in PrusaSlicer. Nothing printing.
Source: print plan §4.3 — spool changes · 00-slicer-setup § Drying · Prusa KB — ASA