Skip to content
Batch B00 › Plate review, B00-P1 and the gates4 / 9

Step B00.2 — Load plate B00-P1

Step 4 of 9 · Batch B00 — Calibration & jigs

gather Gather for this segment — steps B00.2–B00.5 (~15 min)

Hardware

  • 6 files, 8 objects — 4.0 h, 52 g (PrusaSlicer 2.9.6 estimate)

Printed parts

  • Voron_Design_Cube_v7 — from bin 00-jigs
  • Heatset_Practice — from bin 00-jigs
  • MGN12_rail_guide_x2 ×2 — from bin 00-jigs
  • MGN9_rail_guide_x2 ×2 — from bin 00-jigs
  • pulley_jig — from bin 00-jigs
  • z_drive_retainer_a_x2 ×1 — from bin 02-Z0, 02-Z2

Parts:

  • 6 files, 8 objects — 4.0 h, 52 g (PrusaSlicer 2.9.6 estimate)
  • Voron_Design_Cube_v7
  • Heatset_Practice
  • MGN12_rail_guide_x2 ×2
  • MGN9_rail_guide_x2 ×2
  • pulley_jig
  • z_drive_retainer_a_x2 ×1

Do:

  1. File → Open Project: slicer/plates/B00-P1.3mf. Open it, never rebuild it.
  2. Confirm 6 files, 8 objects on the bed and no brim.
  3. Do not change which face a part sits on; rotating about Z is fine.

check Check

The slicer reads 3 h 58 m / 51.7 g, and the filament preset shows shrinkage compensation XY and Z at 0 %.

What you're looking at

Sorting diagram, drawn from the committed project: every part numbered and filled in the colour of its bin, bin id on the part; the legend reads # · STL · bin (chapter · steps). Sort at Step B00.6.

Source: print plan §3 — the batches · 00-slicer-setup § Committed projects · 00-slicer-setup § Orientation & brim · Voron materials — shrinkage 100 %

← PreviousStep B00.1 — Filament prep

Next →Step B00.3 — Pre-print checks