Skip to content
Batch B015 / 8

Step B01.5 — Load plate B01-P2

Step 5 of 8 with a helper · Batch B01 — Z drive assemblies

gather Gather for this segment — steps B01.5–B01.7 (~15 min)

Printed parts

  • z_motor_mount_a ×2 — from bin 02-Z0, 02-Z2
  • z_motor_mount_b ×2 — from bin 02-Z1, 02-Z3
  • z_tensioner_bracket_a ×2 — from bin 02-Z0, 02-Z2
  • z_tensioner_bracket_b ×2 — from bin 02-Z1, 02-Z3
  • deck_support_3mm — 7.6 h, 100 g (PrusaSlicer 2.9.6 estimate) ×8 — from bin 02-deck

Parts:

  • z_motor_mount_a ×2
  • z_motor_mount_b ×2
  • z_tensioner_bracket_a ×2
  • z_tensioner_bracket_b ×2
  • deck_support_3mm ×8 — 7.6 h, 100 g (PrusaSlicer 2.9.6 estimate)

Do:

  1. Open slicer/plates/B01-P2.3mf with File → Open Project. Do not rebuild the plate.
  2. Confirm: 5 files, 16 objects, no brim.

check Check

All 8 clips on the plate, 3 mm per the BOM; the kit-day caliper decides a 4 mm reprint.

helperHelper Counts the parts on the sorting diagram and checks the total against the object count.

What you're looking at

Sorting diagram, drawn from the committed project: every part numbered and filled in the colour of its bin, bin id on the part; the legend reads # · STL · bin (chapter · steps). Sort at Step B01.8.

Caution

z_motor_mount_a/b are 42.0 mm tall, borderline aspect. Only if a motor mount lifts on this print, add a 5 mm brim to those four objects by hand for the reprint: right-click the object → Add settings → Skirt and brim → Brim width. Never the global setting, per 00-slicer-setup.

Source: print plan §3 — the batches · 00-slicer-setup § Committed projects · 00-slicer-setup § Orientation & brim · LDO Rev D printed-parts guide · LDO Rev D 350 BOM

← PreviousStep B01.4 — Print plate B01-P1

Next →Step B01.6 — Print plate B01-P2