Batch B014 / 8
Step B01.4 — Print plate B01-P1¶
Step 4 of 8 · Batch B01 — Z drive assemblies
(no image — see text)
Do: Start in the morning or at the start of a full workday: this is the 15.2 h plate.
Check
First layer clean; no corner lift on the z_drive_main bodies partway through.
Tip
look at the first layer, the corners after an hour, and at bedtime. A lifted corner is a stop. Paused or stopped: When the printer stops.
Good stopping point · ~5 min since the last one
B01-P1 running, 15.2 h unattended, door shut. Meanwhile: read Ch 02, sort the last plate, label bins.
Source: 00-slicer-setup § Overrides · print plan §4.1 — how these numbers were produced