Skip to content
Batch B028 / 9

Step B02.8 — Inspect

Step 8 of 9 · Batch B02 — Accent parts (blue)

(no image — see text)

Do:

  1. Check the SB main body's built-in supports snapped out clean and the LED pockets are crisp. The guidler and latch fit test happens at B06.
  2. Snap the Handle brim off and check the base for scarring.

check Check

No support remnants inside the SB body's cable channels or LED pockets; Handle base clean.

pause Good stopping point · ~10 min since the last one

supports out, brim off, nothing pressed or glued. Leave the blue spool on if B02-P3 has not printed yet; otherwise unload it and re-seal it before walking away.

Source: print plan §5.2 — checkpoint after each batch · 00-slicer-setup § Calibration sequence · Stealthburner manual — remove built-in supports

← PreviousStep B02.7 — Print plate B02-P3

Next →Step B02.9 — Sort into bins