Batch B02Checkpoint
Checkpoint B02¶
Checkpoint · Batch B02 — Accent parts (blue)
- SB main body built-in supports removed clean; LED pockets crisp
- Cable-chain bridge fit decision made (stock 2-hole vs Ti-backer remix) once Ti backers are in hand
-
Handlebrim removed cleanly, no visible scarring - All 29 small accent parts present and in their bins (B02.9), ids written on the
_a/_bparts - Blue spool re-sealed/dry-stored — no more blue prints in the build
Common mistakes¶
- Suppressing the SB main body's built-in supports in slicer instead of leaving them as designed.
- Slicing the Ti-backer cable bridge standing up because it didn't auto-lay-flat.
- Setting a global brim to "make sure"
Handlegets one — it already has one; the global setting brims every grill on the plate. - Mixing up which
a/bpart goes to which corner or side — letter every_a/_bpart as it comes off the plate, before anything is bagged. - Skipping the full purge on the blue colour change and getting black-streaked accent parts.
Next¶
Assembly: accent half of Z Drives and Idlers, A/B Drives and Idlers, Gantry, Stealthburner, Skirts and the Clicky-Clack door — as their black counterparts complete. Printing: back to Galaxy Black for B03 — A/B drive units + front idlers, and on through B10 in numeric order — the whole run is finished before the kit lands.