Skip to content
Batch B031 / 5

Step B03.1 — Filament prep

Step 1 of 5 · Batch B03 — A/B drive units + front idlers

(no image — see text)

gather Gather for this segment — steps B03.1–B03.3 (~5 min)

Hardware

  • 8 objects — 8.5 h, 119 g (PrusaSlicer 2.9.6 estimate)

Printed parts

  • a_drive_frame_lower — from bin 04-A
  • a_drive_frame_upper — from bin 04-A
  • front_idler_right_lower — from bin 04-A
  • front_idler_right_upper — from bin 04-A
  • b_drive_frame_lower — from bin 04-B
  • b_drive_frame_upper — from bin 04-B
  • front_idler_left_lower — from bin 04-B
  • front_idler_left_upper — from bin 04-B

Do: Swap the accent spool for Galaxy Black: Unload, Load Filament → ASA, purge until no blue shows. The ledger has B03 on spool #1 with 447 g, leaving 328 g after. Sheet per 00-slicer-setup § Print sheet.

check Check

Purge clean black, no blue streak.

Source: print plan §4.3 — spool changes · 00-slicer-setup § Drying · Prusa KB — ASA

← PreviousBatch B03 — before you start

Next →Step B03.2 — Load plate B03-P1 (both sides)