Skip to content
Batch B041 / 6

Step B04.1 — Filament prep

Step 1 of 6 · Batch B04 — XY joints + X carriage

(no image — see text)

gather Gather for this segment — steps B04.1–B04.4 (~5 min)

Hardware

  • all seven — 8.6 h, 117 g (PrusaSlicer 2.9.6 estimate)

Printed parts

  • xy_joint_left_lower_MGN12 — from bin 05-XY
  • xy_joint_left_upper_MGN12 — from bin 05-XY
  • xy_joint_right_lower_MGN12 — from bin 05-XY
  • xy_joint_right_upper_MGN12 — from bin 05-XY
  • x_frame_V2TR_MGN12_left — from bin 07-X
  • x_frame_V2TR_MGN12_right — from bin 07-X
  • probe_retainer_bracket — from bin 07-X

Do: Galaxy Black, spool #1 after B03. The ledger has 328 g on it at the start of this plate and 211 g after, so no spool change here.

check Check

Clean purge; ≥117 g on the spool.

Source: print plan §4.3 — spool changes · 00-slicer-setup § Drying · Prusa KB — ASA

← PreviousBatch B04 — before you start

Next →Step B04.2 — Load plate B04-P1