Skip to content
Batch B051 / 5

Step B05.1 — Filament prep

Step 1 of 5 · Batch B05 — Z joints + Z chain

(no image — see text)

gather Gather for this segment — steps B05.1–B05.3 (~5 min)

Hardware

  • the fourteen pieces above — 6.4 h, 78 g (PrusaSlicer 2.9.6 estimate)

Printed parts

  • z_joint_lower_x4 ×4 — from bin 06-Z-joints
  • z_joint_upper_x4 ×4 — from bin 06-Z-joints
  • z_chain_bottom_anchor — from bin 10-chains
  • z_chain_guide — from bin 10-chains
  • z_rail_stop_x4 ×4 — from bin 02-Z0, 02-Z1, 02-Z2, 02-Z3

Do: Galaxy Black, still spool #1. The ledger has 211 g on it here and 133 g after, which is the stub B06 leaves behind. Sheet per 00-slicer-setup § Print sheet.

check Check

Clean purge; ≥78 g on the spool.

Source: print plan §4.3 — spool changes · 00-slicer-setup § Drying · Prusa KB — ASA

← PreviousBatch B05 — before you start

Next →Step B05.2 — Load plate B05-P1