Step B05.2 — Load plate B05-P1¶
Step 2 of 5 with a helper · Batch B05 — Z joints + Z chain
Parts:
- the fourteen pieces above — 6.4 h, 78 g (PrusaSlicer 2.9.6 estimate)
-
z_joint_lower_x4×4 -
z_joint_upper_x4×4 -
z_chain_bottom_anchor -
z_chain_guide -
z_rail_stop_x4×4
Do: Open slicer/plates/B05-P1.3mf with File → Open Project. Arrangement, per-object brims and overrides are already in the project, so confirm it loaded rather than rebuild it. No rotation, no brim. Do not include z_joint_upper_hall_effect.stl.
Check
File list contains only the D2F-compatible z_joint_upper_x4, not the hall-effect variant.
Helper Names the bin colour of each part on the sorting diagram while you open the project.
What you're looking at
Sorting diagram, drawn from the committed project: every part numbered and filled in the colour of its bin, bin id on the part; the legend reads # · STL · bin (chapter · steps). Sort at Step B05.5.
Source: print plan §3 — the batches · 00-slicer-setup § Committed projects · 00-slicer-setup § Orientation & brim · LDO Build Notes / FAQ