Batch B053 / 5
Step B05.3 — Print¶
Step 3 of 5 · Batch B05 — Z joints + Z chain
(no image — see text)
Do: Print with standing overrides.
Check
Before start, Settings → Chamber Filtration reads Adv. Filtration. First layer clean; no warp on the small joint parts.
Tip
Paused or stopped mid-plate? See When the printer stops.
Good stopping point · ~5 min since the last one
plate started; nothing to do until it finishes.
Source: 00-slicer-setup § Overrides · print plan §4.1 — how these numbers were produced