Skip to content
Batch B061 / 5

Step B06.1 — Filament prep

Step 1 of 5 · Batch B06 — Toolhead: Stealthburner, Clockwork 2, Klicky

(no image — see text)

gather Gather for this segment — steps B06.1–B06.3 (~5 min)

Hardware

  • 18 files, 19 objects, no brim in the project — 12.1 h, 148 g (PrusaSlicer 2.9.6 estimate)

Printed parts

  • stealthburner_printhead_revo_voron_front — from bin 08-SB
  • stealthburner_printhead_revo_voron_rear_cw2 — from bin 08-SB
  • [o]_stealthburner_LED_carrier — from bin 08-SB
  • [o]_stealthburner_LED_diffuser_mask — from bin 08-SB
  • main_body (CW2) — from bin 08-CW2
  • motor_plate (CW2) — from bin 08-CW2
  • cw2_captive_pcb_cover — from bin 08-CW2
  • then the Klicky set — KlickyProbe_v2 ×2 — from bin spare-alt
  • Probe_Dock_v2.1 — from bin spare-alt
  • Probe_magnet_holder — from bin spare-alt
  • Probe_magnet_pressfit_helper — from bin spare-alt
  • Probe_pressfit_holder — from bin spare-alt
  • KlickyProbe_AB_mount_v2 — from bin spare-alt
  • KlickyProbe_AB_mount_v2_holder — from bin spare-alt
  • Mount_magnet_holder — from bin spare-alt
  • Mount_magnet_pressfit_helper — from bin spare-alt
  • Mount_pressfit_holder_v2 — from bin spare-alt
  • Dock_mount_fixed_v2 — from bin spare-alt

Do: Galaxy Black on a fresh spool #2: spool #1 holds only 133 g after B05, and this plate carries the Revo seat. Keep the stub for a clip reprint. Sheet per 00-slicer-setup § Print sheet.

check Check

Clean purge; spool #2 mounted and ≥148 g on it.

Source: print plan §4.3 — spool changes · 00-slicer-setup § Drying · Prusa KB — ASA

← PreviousBatch B06 — before you start

Next →Step B06.2 — Load plate B06-P1