Skip to content
Batch B081 / 11

Step B08.1 — Filament prep

Step 1 of 11 · Batch B08 — Skirts and front modules

(no image — see text)

gather Gather for this segment — steps B08.1–B08.3 (~5 min)

Hardware

  • 3 mm brim on both, already in the project

Printed parts

  • rear_center_skirt_350 — from bin 11-skirts
  • side_fan_support — 6.3 h, 99 g (PrusaSlicer 2.9.6 estimate) ×1 — from bin 11-skirts

Do: Galaxy Black, spool #2 after B07: 426 g at the start of P1, 27 g after P4, so no runout here. The one predicted runout is the next plate. Sheet per 00-slicer-setup § Print sheet, renewing the glue film.

check Check

Spool #2 has ≥399 g for the four plates before the 6.3 h P1 plate starts.

Source: print plan §4.3 — spool changes · 00-slicer-setup § Drying · Prusa KB — ASA

← PreviousBatch B08 — before you start

Next →Step B08.2 — Load plate B08-P1