Skip to content
Batch B086 / 11

Step B08.6 — Load plate B08-P3

Step 6 of 11 with a helper · Batch B08 — Skirts and front modules

gather Gather for this segment — steps B08.6–B08.7 (~5 min)

Hardware

  • 3 mm brim on the three skirt parts, none on the TFT mount, all as shipped in the project

Printed parts

  • side_fan_support ×1 — from bin 11-skirts
  • side_skirt_a_350 ×1 — from bin 11-skirts
  • side_skirt_b_350 ×1 — from bin 11-skirts
  • mount.stl — 9.5 h, 122 g (PrusaSlicer 2.9.6 estimate) — from bin 10-tft

Parts:

  • side_fan_support ×1
  • side_skirt_a_350 ×1
  • side_skirt_b_350 ×1
  • mount.stl — 9.5 h, 122 g (PrusaSlicer 2.9.6 estimate)
  • 3 mm brim on the three skirt parts, none on the TFT mount, all as shipped in the project

Do: Open slicer/plates/B08-P3.3mf with File → Open Project. The arrangement, brims and overrides are already in it. Confirm it loaded as described rather than rebuilding it.

check Check

Brim outline on the three skirt parts, none on the mount; confirm mount.stl, not mount_thick.stl.

helperHelper Names the bin colour of each part on the sorting diagram while you open the project.

What you're looking at

Sorting diagram, drawn from the committed project: every part numbered and filled in the colour of its bin, bin id on the part; the legend reads # · STL · bin (chapter · steps). Sort at Step B08.11.

Source: print plan §3 — the batches · 00-slicer-setup § Committed projects · 00-slicer-setup § Orientation & brim · LDO Rev D printed-parts guide

← PreviousStep B08.5 — Print plate B08-P2

Next →Step B08.7 — Print plate B08-P3