Batch B08Checkpoint

Checkpoint B08

Checkpoint · Batch B08 — Skirts and front modules

• All ten skirt segments plus TFT mount pass the flat-reference rocking test
• Full ring dry-fits: front, rear, and both sides, with consistent joint gaps (power inlet from B07)
• mount.stl vs mount_thick.stl choice confirmed and matches what was printed
• 3 mm brims removed cleanly from all long-flat parts

Batch B08 printed: plates 13 to 16 of 22, 129.5 of 157.0 h. 4 gummy worms.

Common mistakes

• Skipping the flat-reference check and only noticing a bowed skirt after the panels are mounted.
• Slicing mount_thick.stl by accident when the plan calls for mount.stl.

Next

Assembly: Skirts (Ch 11 Part A, p.212–239). Printing: B09 — Panels, filtration, spool.

← PreviousStep B08.11 — Sort into bins

Next →Batch B09 — before you start