Skip to content
Batch B091 / 13

Step B09.1 — Filament prep

Step 1 of 13 · Batch B09 — Panels, filtration, spool

(no image — see text)

gather Gather for this segment — steps B09.1–B09.3 (~5 min)

Printed parts

  • V2_Duo_Plenum, 3 mm brim already in the project — from bin 11-nevermore
  • V2_Duo_Plenum_LID, no brim — from bin 11-nevermore
  • Regular_Cartridge_Lid, no brim — 4.5 h, 63 g (PrusaSlicer 2.9.6 estimate) — from bin 11-nevermore

Do: Galaxy Black. Spool #2 starts B09-P1 with about 27 g left, so the build's one predicted runout lands inside that plate; P2 to P5 run on spool #3, per the ledger. Sheet per 00-slicer-setup § Print sheet.

check Check

Clean purge; spool #3 unsealed and within reach for the runout-sensor pause.

Source: print plan §4.3 — spool changes · 00-slicer-setup § Drying · Prusa KB — ASA

← PreviousBatch B09 — before you start

Next →Step B09.2 — Load plate B09-P1